Tecnai on-line help manual -- Options - UT Southwestern

<strong>Tecnai</strong> on-line help Options 44Options Software version 2exist after insertion of the montage data, the excess lines will be lost and not restored afterwards). Afterthe exposure procedure is stopped, the film text is restored to its original setting (minus any excess lineslost).Exposures that have been recorded will have their plate exposure numbered entered in the list and, ifsufficient space is available, their label on the screen is also replaced by the exposure number. IF theexposures are recorded on a CCD camera the exposure numbers given are 'CCD1', 'CCD2', etc.Note: While exposing (both automatic and manual), the program uses a backlash correction procedureto make the positioning the exposures more accurate. However, because the backlash correction(probably) wasn't done during definition of the boundaries, there may be a systematic shift of the wholepattern of exposures of up to about 500 nm. For montages at high magnifications it is important thereforeto check the exposure locations (e.g. go to selected exposure locations through their hyperlabels),especially if the edge of the area covered by the exposures is close (less than 1 um) to the intendedphotomontage area.