Download - Freiwald Software

Notes:
This is a very rough explanation of the setup. Detailed instructions would be out of proportions
of this manual. This example should give you a first idea how the mechanism
works in principle.
The key is the usage of the on-off switch as a memory. It is turned on at the beginning
of the move to the destination track and it ensures that the turntable is correctly stopped
at the right track.
Normally you will create two on-off switches for each track, one for each direction.
A problem might arise due to the fact that in many cases stopping of the bridge must be
triggered just before the bridge reaches the destination track rather than just after arrival
in order to stop the movement in time.
Transfer tables are setup for indexing accordingly.
Setup of a generic turntable for indexing is done in the same way. The only further
measure to be taken is setup of additional operations for the commands normally supported
by analog turntables as displayed in Diagram 172.
244