Strato X User Manual - Image Works
Strato X User Manual - Image Works
Strato X User Manual - Image Works
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
USER'S MANUAL<br />
General instructions for use<br />
4. Display will show:<br />
L O N G I T O F F S : > + 0 0<br />
T R A N S V O F F S : > + 0 0<br />
Input data of the offset for longitudinal and cross slices using<br />
buttons "26" or "24" ; in this way it is possible to set<br />
the correct value with its sign; using buttons "22" or "25"<br />
it will be possible to change the offset in the range ±10units of the<br />
ruler. Set values must be confirmed using button "23" .<br />
If reduced implant has been chosen, jump to point 6.<br />
5. If complete examination has been selected, display will show:<br />
D I S T A N C E : 2 m m<br />
5 8 k V 0 7 m A 0 3 . 5 s<br />
Where the displayed values are those of the cross slices.<br />
Select the spacing between cross slices in one of the values 2, 3 or<br />
4 mm using buttons "26" or "24" .Confirm the set value<br />
using button "23" .<br />
6. Display will visualise:<br />
P A T I E N T E N T R Y<br />
5 8 k V 0 7 m A 0 3 . 5 s<br />
Where the displayed values are those of the cross slices.<br />
<br />
NOTE:<br />
Indicated exposure time is strictly dependent on the selection of<br />
tomographic images parameters.<br />
(Rev. 1)<br />
95<br />
STRATO X (120V)