Strato X User Manual - Image Works

USER'S MANUAL
General instructions for use
WARNING:
The position of the identification characters "R" (right side) and "L" (left
side) are correct if the cassette is fit into the unit with the hinges
positioned upward.
NOTE:
The rotation of the arm and the emission of the X-rays will start with a
delay of 2 seconds from pressing the X-ray button "30". Since the X-ray
button is a "dead man" control, it must be kept pressed until the end
of the exposure.
The X-rays emission to the central part of the dental arch is suspended
during the examination phase, the relative signals (sound and visual) are
therefore also suspended.
2. Once the exposure is completed, the system will carry out a short
return rotation and the following message is displayed:
P A T I E N T E X I T
P R E S S → 0 ←
It will then be possible to setup the system for the open mouth
examination, keeping the patient in position or letting him free.
3. Press button "10" . The machine will return to its initial
position and the following message will be displayed
P L E A S E W A I T . . .
When the machine stops, the key "23" LED will light up and the
following message will be displayed:
I N S T R U C T P A T I E N T
T O O P E N M O U T H !
(Rev. 1)
59
STRATO X (120V)