Strato X User Manual - Image Works

USER'S MANUAL
General instructions for use
6.7.1 Linear tomography programs
STRATO X allows performing the linear tomography in two ways that are
very similar on the conduction of the examination but gives a different
result on film. The first mode, called “complete examination”, results on
a 4 radiographs: one longitudinal image and three cross ones; of these
last, the second one is centred on the point of interest. Referring to
Figure 20, the numbered slices are:
1: longitudinal image, centered on point of interest
3: transversal image, centered on point of interest
2 - 4: other transversal images
1
4
3
2
Figure 20
The second modality, called “reduced implant” gives two images, one
longitudinal and one cross, both centred on the point of interest.
Referring to Figure 21, numbered slices are, respectively:
1: longitudinal image, centered on point of interest
2: transversal image, centered on point of interest.
STRATO X (120V) 78
(Rev. 1)