Strato X User Manual - Image Works
Strato X User Manual - Image Works
Strato X User Manual - Image Works
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
USER'S MANUAL<br />
General instructions for use<br />
6.9 Messages on display<br />
STRATO X is fully controlled by a microprocessor which controls the<br />
programming of the emission parameters and signals the various<br />
conditions of the machine, the possible abnormalities and errors via<br />
displayed messages.<br />
The messages can be divided into two groups:<br />
• operation messages: these messages tell the operator how to set up<br />
the unit for the examination<br />
• error messages: these messages are displayed when an error occurs.<br />
There are three kinds of error messages as follows:<br />
1 - Messages prompted when the X-ray emission button is released by<br />
the operator or by pressing key "9"<br />
. The message displayed<br />
will be as follows<br />
E x x x<br />
P R E S S R E S E T<br />
xxx = error message code number<br />
Operations are reset by pressing key "9" .<br />
2 - Messages generated by a system error. In this case, the Technical<br />
Service must be called.<br />
Messages that require the intervention of the Technical Service are<br />
displayed as follows:<br />
E x x x<br />
C A L L T E C H A S S .<br />
xxx = error message code number<br />
3 - Messages related to H.F. board problems. If this occurs, switch off<br />
the unit. Wait a few minutes for the capacitors of the relative circuit<br />
to discharge and then switch the machine on again. If the problem<br />
persists, call the Technical Service.<br />
E x x x<br />
S W I T C H P O W E R O F F<br />
xxx = error message code number<br />
Those messages requiring the intervention of the Technical Service<br />
together with the relative verifications and actions are listed here<br />
below.<br />
STRATO X (120V) 116<br />
(Rev. 1)