Strato X User Manual - Image Works
Strato X User Manual - Image Works
Strato X User Manual - Image Works
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
USER'S MANUAL<br />
Cleaning and disinfection<br />
4.2.1 Film / Screen combinations<br />
To get a good image quality, it is advisable to match the intensifying<br />
screens and the films, as indicated hereafter:<br />
Supplier Films Sensibility Screen<br />
KONIKA MG Verde KR II<br />
KONIKA MGH Verde KR II<br />
KODAK T-MAT G/RA Verde Lanex Regular<br />
AGFA HTA Verde Medium<br />
FUJI HR-G Verde G8<br />
IMATION XDA Verde T 16<br />
KODAK T-MAT G/RA Verde Lanex Medium<br />
STERLING ULTRAVISION Blu Ultravision Rapid<br />
Table 1<br />
<br />
NOTE:<br />
It is advisable to use always films and screens of the same brand.<br />
Combinations of films and screen of different manufacturer are possible<br />
so long as the same sensitivity is maintained. Never combine films and<br />
screens with different sensibility (green and blue).<br />
The factory set values of the exposure factors listed in paragraph 6.12.4,<br />
as default, are indicative and optimised for the combination film/screen<br />
supplied with the device (film T-MAT G/RA and screens Lanex Regular or<br />
film KONICA MG and KONICA screens). For the other combinations listed<br />
in the table or for further combinations, the exposure factors have to be<br />
modified accordingly by acting as described in paragraph 6.12.<br />
The real adjustment of these values depends on different conditions such<br />
as the preference of the user for much or less exposed images.<br />
The quality of the image, therefore, does not exclusively depend on<br />
STRATO X but it is also extremely important to pay attention to the<br />
processing procedure of the films and the materials related<br />
<br />
NOTE:<br />
Perform the maintenance of the film processor as described in the related<br />
instruction manual.<br />
Regularly check the levels of the used chemical substances; replace them<br />
regularly as indicated by the manufacturer (or according to the number<br />
of processed films).<br />
STRATO X (120V) 10<br />
(Rev. 1)