Strato X User Manual - Image Works

More documents

Recommendations

Info

USER'S MANUAL General instructions for use WARNING: The position of the identification characters "R" (right side) and "L" (left side) are correct if the cassette is fit into the unit with the hinges positioned upward. NOTE: The rotation of the arm and the emission of the X-rays will start with a delay of 2 seconds from pressing the X-ray button "30". Since the X-ray button is a "dead man" control, it must be kept pressed until the end of the exposure. 2. Once the exposure is completed, the system will rotate back to a position where it is possible to make the patient to exit. At the end of this movement, the following message will be displayed: P A T I E N T E X I T P R E S S → 0 ← At this point, the patient can be freed from the positioning device. NOTE: If the examination is made in "Test" mode with the patient already in position, he must not be removed from the temple support group to avoid having to reposition him. Press button "10" to return the unit to its initial position. This movement can be stopped by pressing button "9" . Now the system is ready to perform a new exam. 3. Press button "10" . The unit will return to its initial position and the following message will be displayed: P L E A S E W A I T . . . WARNING: During this phase the system stores into the internal memory some data. Switching off the unit during this phase can lead to the loss of some set-up data normally stored in the memory, which in turn may cause irreversible damages to the system itself. Do not switch off the unit in this phase. If required, switch off the unit only when the green LED "23" is lit. (Rev. 1) 47 STRATO X (120V)
USER'S MANUAL General instructions for use Then, the following message will be displayed: R E P L A C E C A S S E T T E Once the cassette has been removed, LED "23" and the following message will be displayed: will light up x x k V x x m A 1 5 . 0 s x = the value defined by the settings that shows the values set for that last exposure. A new exposure can now be made. NOTE: If you try to perform a new exam before the cooling period has elapse (4 minutes) the following message will be displayed indicating the time to wait before performing a new examination: T U B E C O O L I N G P L E A S E W A I T x x x s This time enables the X-ray tube's anode to cool down. 4. Once the cassette has been removed, it can be opened in a dark room and the film developed. WARNING: After every examination, clean the chin support, the handles and the temple support thoroughly and replace the rod and disposable bite. STRATO X (120V) 48 (Rev. 1)
Page 1 and 2:
STRATO X 0434 (120V version) User's
Page 3 and 4: USER'S MANUAL Revision history THIS
Page 5 and 6: USER'S MANUAL Contents 6.5 TMJ exam
Page 7 and 8: USER'S MANUAL Contents THIS PAGE IS
Page 9 and 10: USER'S MANUAL Safety information 2.
Page 11 and 12: USER'S MANUAL Safety information Th
Page 13 and 14: USER'S MANUAL Safety information 2.
Page 15 and 16: USER'S MANUAL Cleaning and disinfec
Page 23 and 24: USER'S MANUAL Technical specificati
Page 39 and 40: USER'S MANUAL General instructions
Page 53: USER'S MANUAL General instructions
Page 105 and 106:
USER'S MANUAL General instructions
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
Page 143 and 144:
Page 145 and 146:
Page 147 and 148:
Page 149 and 150:
USER'S MANUAL Maintenance MAINTENAN
show all

Strato X User Manual - Image Works

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?