Strato X User Manual - Image Works

USER'S MANUAL
General instructions for use
• Blurred film
Possible cause:
This problem is normally coupled to the presence of poor brightness
in the areas with metal parts.
This may indicate a problem of the dark room (the film has been
exposed to the light during the handling), or to the wrong storage of
the film package or, the films themselves are expired.
Also the film package has been unintentionally exposed to X-ray.
Remedy:
Avoid the above conditions.
• One side of the film is overexposed
Possible cause
The film was already exposed
Light filters through the dark room
or in the cassette
The cassette has not been properly
closed
Remedy
Check the film package, if exposed
by mistake or casually, replace it
with a new one; take care of not
expose it to X-ray or light
Check for the presence of light in the
dark room and eliminate it. Use
special lamps in the dark room
Close correctly the cassette before
exiting from the dark room with a
new film
(Rev. 1)
137
STRATO X (120V)