Strato X User Manual - Image Works

USER'S MANUAL
General instructions for use
WARNING:
Clean the edentulous chin support, the handles and the temple support
thoroughly after each examination.
NOTE:
If, during the exposure the patient moves or the unit collides with the
patient or with another structure, or the operator realises that the
parameters set are incorrect, the X-ray button "30" must be released
immediately, thus suspending emission of the X-rays and the movement
of the arm.
If this occurs, the following message will be displayed:
E 5 6 1
P R E S S R E S E T
All the motors will be switched off and it will be possible, if necessary, to
manually rotate the arm and allow the patient to move away from the
unit. It is recommended that this movement be made with great care
in order to prevent damage to the machine.
Press button "9"
. The following message will be displayed:
M A C H I N E S E T T I N G
Press key "23"
. The following message will be displayed:
W A I T F O R
M A C H I N E S E T T I N G
and then:
R E P L A C E
C A S S E T T E
The system now returns to its initial position and the unit must be reset
(cassette and parameters) and the patient can be repositioned.
NOTE:
If the open mouth exposure is not completed, the closed mouth exposure
must be repeated or the four complete pictures will not appear on the
same plate.
No warning message will be given if the cassette is removed but the film
is not replaced, and another exposure is made. However, the film would
provide non-diagnostic results due to the double exposure.
STRATO X (120V) 64
(Rev. 1)