BC-3500 Series - Rowe International

Section 4: Troubleshooting
EXTRA COIN - R HOP
Symptom:
More than one extra coin was detected passing through the right detector.
Corrective Action:
Since last time bill changer was reset, the bill changer may have dispensed two more coins than it should have during
the replenish cycle. One of the buckets could have an incorrect change load.
1. Most likely, the problem is not electrical. Probable causes are: Faulty hopper motor brakes, or worn parts
on hopper motors.
2. Also, the possible cause could be intermittent connections to the coin detectors, detector LEDs, or wiring.
3. To restore the bill changer to operation, press the FUNCTION button after correcting the problem.
For a more complete troubleshooting sequence, refer to Troubleshooting Chart 050 at the end of this EXTRA
COIN troubleshooting.
25238801 4-41