BC-3500 Series - Rowe International
BC-3500 Series - Rowe International
BC-3500 Series - Rowe International
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>BC</strong>-<strong>3500</strong> Bill and Coin Changer<br />
Coin Counting Phototransistor (Detector) Check<br />
1. Turn the bill changer POWER switch OFF.<br />
2. Remove the black plastic cover from the<br />
phototransistor and connect the Common meter<br />
lead to the metal dispenser backing plate as shown<br />
in Figure 3-6A.<br />
3. Connect the + meter lead to the blue wire. (See<br />
Figure 3-6A).<br />
4. Turn the POWER switch ON and check that the<br />
LED’s are lit. The meter should indicate between<br />
4.7 and 5.2 volts DC.<br />
If the meter indication is not correct, the voltage regulator<br />
VR801 on the power supply board (Part Number<br />
70036501) may need replacement.<br />
= Blue Wire<br />
= Orange Wire<br />
Figure 3-6A. Sensor Check<br />
5. If the meter indication in Step 4 is correct, continue<br />
this procedure. If the voltage was not between 4.7<br />
and 5.2 volts, repair the malfunction before you<br />
continue.<br />
6. Move the + meter lead to the orange wire on the<br />
phototransistor as shown in Figure 3-6B. The<br />
meter should indicate between 3.5 and 5.0 volts<br />
DC.<br />
If the voltage is less than 3.5 volts, replace the<br />
phototransistor board assembly with Part Number<br />
25175702.<br />
= Blue Wire<br />
= Orange Wire<br />
Figure 3-6B. Sensor Check<br />
3-8 25238801