BC-3500 Series - Rowe International
BC-3500 Series - Rowe International
BC-3500 Series - Rowe International
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>BC</strong>-<strong>3500</strong> Bill and Coin Changer<br />
STATUS DISPLAY<br />
The CCC contains many programming and self-diagnostic features which are described in the paragraphs that follow.<br />
All messages are shown on a 16-character vacuum fluorescent display. In some cases, the message is short enough<br />
so that the word(s) can be spelled out: in other cases the word(s) are abbreviated. The abbreviations are clear and<br />
logical and each message is described in Section 4 of this manual.<br />
SERVICE AND CONTROL SWITCHES<br />
The <strong>BC</strong>-<strong>3500</strong> Bill Changer’s service features and programming options are controlled by six switches. The<br />
descriptions that follow are introductory; follow the detailed procedures and instructions in Section 2 for specific<br />
operating and programming information.<br />
Programming/Normal<br />
Select either the NORMAL operating mode or the PROGRAMMING mode.<br />
NORMAL POSITION<br />
In the NORMAL mode position, the changer operates in a normal manner. The CCC monitors all systems for faults<br />
or customer input.<br />
The VALUE and HOPPER buttons provide unique features while the machine is in the NORMAL mode.<br />
Value Button<br />
Pressing the VALUE button will cause the display to show the total dollar amount accepted since the temporary audit<br />
value was cleared. Thus, if you clear this audit counter (see Section 2) each time you load the hoppers, you can<br />
quickly see how much change has been paid out and thus determine whether or not the bill changer needs to be loaded<br />
again.<br />
Hopper Button<br />
Pressing the HOPPER button will cause the display to show the last three denominations accepted. The most recent<br />
denomination is displayed on the left side, the bill before that is displayed on the right side. If a test vend in included<br />
in this list, the display will show: “TVL”, “TVC”, or “TVR” (depending on which TEST VEND switch was pressed)<br />
in its proper position on the display. If a coin was accepted, the display will show “25”, “50”, or “$1C” on the display<br />
in its proper sequential position (left, center, or right position).<br />
When the PROGRAMMING/NORMAL switch is moved from PROGRAMMING to the NORMAL position, the<br />
message “STORING NEW DATA” will be displayed.<br />
PROGRAMMING POSITION<br />
Setting the PROGRAMMING/NORMAL switch to the PROGRAMMING position allows you to inspect and/or change<br />
the audit and setup information. This information is displayed on the status display and is selected and changed by<br />
using the five pushbuttons that are described in the following paragraphs (see Section 2: Changing Payout<br />
Programming Also):<br />
1-10 25238801