BC-3500 Series - Rowe International

BC-3500 Bill and Coin Changer
CLEANING THE HOPPER COIN PATH
The coin tracks are Teflon coated to minimize dirt buildup.
It may still be necessary to clean them at regular intervals,
as dictated by the number of vends and the environment,
to prevent dirt accumulation in the coin path.
Failure to keep the coin path clean may result in coins
sliding out of the track, indicating an empty condition even
though the hopper contains sufficient coins. Clean the
hoppers as follows:
Clean top and
angular coin
path surfaces,
especially at
guide edges,
as shown
1. Remove the hopper from the bill changer and place
it on a working surface.
2. Remove all the screws pointed out in Figure 3-4B,
and lift the back chain plate assembly up so that the
tab (enlarged below) can be pulled through the right
hand side plate of the hopper assembly. Pull the
chain plate assembly straight back out and you will
now be able to access the coin path more easily for
cleaning.
Figure 3-4A. Cleaning the Hopper
Coin Path
Figure 3-4B
3-4 25238801