BC-3500 Series - Rowe International
BC-3500 Series - Rowe International
BC-3500 Series - Rowe International
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>BC</strong>-<strong>3500</strong> Bill and Coin Changer<br />
BILL RETURN SWITCH ADJUSTMENT<br />
Refer to Figure 3-8 for this service check and adjustment. This switch must be in the actuated condition (the plunger<br />
is pushed in) when the machine is in standby and the BILL AND COIN RETURN button not depressed.<br />
The switch should transfer and put the bill acceptor motor in reverse when the BILL AND COIN RETURN button is<br />
depressed slightly (1/8 to 1/4 inch). If adjustment is necessary:<br />
1. Open the top door.<br />
2. Locate the two return switch mounting screws<br />
at A.<br />
A<br />
3. Insert a small (#1) Phillips screwdriver through<br />
the side of the partition as shown in Figure 3-8,<br />
reference B and loosen both of the return switch<br />
mounting screws. Loosen the mounting screws<br />
only enough to allow the front end of the switch<br />
to rotate freely.<br />
B<br />
4. Pull the front (near you) end of the switch down<br />
as far as it will go, then push the switch upward<br />
until the switch “clicks.”<br />
5. While holding the switch in place, tighten the two<br />
switch mounting screws.<br />
6. Check for proper operation and repeat Steps 3<br />
through 5 if necessary.<br />
Figure 3-8. Bill Return Switch Adjustment<br />
Hopper Chain Adjustment<br />
NOTE:<br />
Make sure the hopper is empty of all coins before you adjust the chain tension.<br />
1. Loosen the three screws at the top back of the hopper, which will allow the black plastic upper chain guide<br />
ring to move diagonally upwards, as shown in Figure 3-9.<br />
2. Pull the upper chain guide ring up as shown in Figure 3-9, while you rotate the drive pin clockwise until the<br />
slack is removed from the chain but no binding is evident.<br />
3-10 25238801