BC-3500 Series - Rowe International
BC-3500 Series - Rowe International
BC-3500 Series - Rowe International
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>BC</strong>-<strong>3500</strong> Bill and Coin Changer<br />
1. Insert a bill into the transport upside down. The bill will be rejected and the status display should show<br />
“REJECT-BILL (A)”.<br />
2. Hold the bill in the transport. Do not uncover the VI cell. Wait five seconds for the transport to start to cycle<br />
reverse-forward-reverse-forward-reverse. The transport will do this three times if the VI cell is kept<br />
covered. During the self-clear operation, the status display will show the message “PURGING ACCEP-<br />
TOR”.<br />
3. The motor will stop and the status message will change to “CK TRANSPORT VI”. (If the VI cell is uncovered<br />
any time during the self-clear cycle, the machine will automatically go back into operation.<br />
4. Restore the machine to service by removing the bill.<br />
ACCEPTANCE CHECK<br />
To aid in checking acceptance, set the BILL TEST mode to ON. This will allow checking out the validation portion<br />
of the system without paying out coins.<br />
NOTE:<br />
The bill acceptor may reject bills if a bright light source shines into the transport.<br />
Close the top door of the changer to prevent this problem.<br />
1. Make certain that the bill is programmed to be accepted.<br />
2. Insert a dollar bill upside down. The bill should reject and the display should show “REJECT-BILL (A)”.<br />
3. Insert the dollar bill correct side up, but backwards. The bill should reject a message “REJECT-BILL (B)”.<br />
(Be sure BILL B CHECK is ON.)<br />
Now insert the dollar correctly. It should accept and the stacker should operate.<br />
Also, as the bill moves through the bill acceptor, check to ensure that the following messages are shown on the<br />
status display:<br />
1. “VALIDATING” will appear as the bill is inserted and while the transport is running.<br />
2. “GOOD $1” will appear when the bill is validated and stacked.<br />
3. If bills in good condition are rejected frequently, note the reject message on the status display and refer to<br />
Section 4 for troubleshooting information.<br />
4. If the machine is set up to accept other bills, the previous checks should also be performed with all other<br />
denominations.<br />
When the other denominations are accepted, the display will show “GOOD $XX”, where XX represents the<br />
denomination.<br />
2-16 25238801