BC-3500 Series - Rowe International
BC-3500 Series - Rowe International
BC-3500 Series - Rowe International
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Section 4: Troubleshooting<br />
REJECT - LOST TACH<br />
Symptom:<br />
The tach signal from the transport was lost.<br />
This is a reject message.<br />
The bill was rejected because the CCC cannot control the transport motor speed without a tach. signal.<br />
Corrective Action:<br />
1. An object is possibly hung-up or jammed in the track.<br />
2. Check for a tach. signal as outlined in Test Procedures in Section 3. Replace the transport if the tach. is bad.<br />
3. Check for intermittent connections in the wiring from the transport to the CCC (P4- Pin 9).<br />
4. If all of the preceding checks are OK, replace the CCC.<br />
REJECT - VF OPEN<br />
Symptom:<br />
The flipper cell opened too soon.<br />
This is a reject message.<br />
The bill was rejected because the VF cell opened during validation.<br />
The bill is possibly torn, or it may have a hole in it.<br />
An object is possibly hung-up or jammed in the track near the flipper.<br />
If bills are frequently rejected for this message, take the following corrective action:<br />
Corrective Action:<br />
1. Check for tight, binding, or sticky flipper operation.<br />
2. Check for an intermittent open circuit in the wiring to the VF cell from CCC (P4- pin 7).<br />
3. If the preceding checks do not find the problem, replace the CCC.<br />
If a bill is left in the transport for five seconds, the bill changer will go into SELF-CLEAR.<br />
25238801 4-15