BC-3500 Series - Rowe International
BC-3500 Series - Rowe International
BC-3500 Series - Rowe International
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Section 3: Routine Service<br />
Adjusting the Bill Transport To Stacker Alignment<br />
After adjusting the Coin Inlet To Top Door Clearance as described earlier in this section, loosen the two screws<br />
as shown in Figure 3-10B. With the bill acceptor flush with the coin inlet trim, pull the bill stacker as far forward<br />
as possible. After tightening the screws, make sure that the rear of the transport side plates and the bill acceptor stop<br />
plate on the stacker are flush to within 1/32 inch as shown in Figure 3-10B.<br />
0 to 1/32 Inch<br />
Figure 3-10B. Bill Transport to Stacker Alignment<br />
Bill Stacker<br />
HOME SWITCH ADJUSTMENT<br />
A stacker cycle will start each time a TEST switch is<br />
pressed. Adjust the stacker HOME switch as follows:<br />
1. Turn the power OFF and remove the bill stacker<br />
from the bill changer.<br />
2. Hold the motor brake IN (disengaged) and manually<br />
rotate the motor shaft until the stacker is in the HOME<br />
position (the stacker push plate is at its inner most<br />
position).<br />
Cam<br />
Spring<br />
3. Disconnect the lower link and move it to the side.<br />
4. Adjust the cam switch by loosening the adjustment<br />
screw and rotating the switch until the cam pushes<br />
the spring against the switch body as shown in<br />
Figure 3-11.<br />
5. Tighten the adjustment screw, reconnect the lower<br />
link and install the bill stacker in the bill changer.<br />
Lower Link<br />
Removed<br />
Adjustment<br />
Screw<br />
Figure 3-11. Stacker Switch Adjustment<br />
6. Turn the power ON and check stacker operation.<br />
25238801 3-13