BC-3500 Series - Rowe International

BC-3500 Bill and Coin Changer
Figure 2-4. Unloading the Hoppers
4. Hoppers may also be removed from the machine and inverted over the bag to empty. When replacing the
hopper, be sure it is sitting securely in the pivot brackets and snug against the back plate.
5. Empty the change from each of the change escrow buckets by pressing a TEST VEND switch. When the hopper
motors start, turn the bill changer power OFF then ON. Repeat for each of the three TEST VEND switches.
This will completely empty the changer of all coins.
OPERATIONAL INFORMATION
The bill and coin changer uses several visual indicators and controls. The location of these controls and indicators
are as follows:
ON-OFF Switch
Circuit Breakers
Dollars Accepted Counter
Test Switches
Voltage LED’s
SERVICE/PROGRAMMING
Switches
Status Display
BILL RETURN Switch
Located on the front of the power control center
Located on the front of the power control center (four total)
Located on the front of the power control center
Located on the front of the power control center (three total)
+5 VDC, +12 VDC, +30 VDC, and +40 VDC are located on the front of the power control
center
Located on the computer control board
Located on the computer control board
Located behind the BILL RETURN button on the front of the top door
2-6 25238801