BC-3500 Series - Rowe International

Section 3: Routine Service
Adjusting the Upper Bill Box
Refer to Figure 3-13 as you do the following four steps.
1. Make sure that the upper bill box (C) is tight against chute guides (A). If it is not, do the following procedure:
2. Loosen the two #8-32 screws (B) on each of the two support brackets (D). Push the upper bill box (C) tight
against chute guides.
3. Push the support brackets until the bill box catch wire (E) is horizontal and tight against the bill box.
4. Tighten the four #8-32 screws (the bill box catch wire must fall over the bill box, and the bill box must not move
during stacking cycle.
D
B
E
Upper Bill Box
A
C
Lower Bill Box
Figure 3-13. Upper Bill Box Adjustment
25238801 3-15