BC-3500 Series - Rowe International

BC-3500 Bill and Coin Changer
Adjusting the Stacker Pusher Plate
1. Turn the power OFF and remove the stacker from the changer.
2. Loosen the four mounting screws holding the motor plate as shown in Figure 3-12.
3. Hold the motor brake IN (disengaged) and manually rotate the motor shaft until the cam activates the stacker
switch.
4. Lay the bill stacker on its side with motor on top. Turn the motor shaft until the pusher plate is all the way back.
5. Move the pusher plate out by prying on the top end of the pusher plate with a small screw driver until it is
approximately 1/8 inch past the hole in the top support plate as shown in Figure 3-12.
6. Tighten the four motor mounting screws and install the stacker in the bill changer.
7. Turn the power ON and check stacker operation.
.160/.110
Top
Support
Plate
Push
Plate
Figure 3-12. Pusher Plate Adjustment
3-14 25238801