BC-3500 Series - Rowe International

BC-3500 Bill and Coin Changer
REJECT - SPEED
Symptom:
The transport motor speed is not correct.
This is a reject message.
The bill was rejected because the transport motor did not run at a constant speed during validation.
Corrective Action:
1. An object is possibly hung-up or jammed in the track.
2. If bills are frequently rejected for this message, check for tight, binding, or sticky rollers, belts, or flipper.
3. Check that the timing belt tension is not too tight.
4. Check that the +12 VDC supply in the power control center is correct.
5. Check for an intermittent connection in the wiring for the +12 VDC supply, the Red, Black, and Shield wires,
or the White/Black encoder signal wire.
6. Check the motor and timing gear backlash.
7. If all of the preceding checks are OK, replace the transport.
8. If the problem still exists, replace the CCC.
9. Replace the power control center if replacing the CCC does not correct the problem.
If a bill is left in the transport for more than five seconds, the bill changer will go into SELF-CLEAR.
4-14 25238801