5-speed manual gearbox 0A4.pdf
5-speed manual gearbox 0A4.pdf
5-speed manual gearbox 0A4.pdf
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted unless authorised by Volkswagen AG. Volkswagen AG does not guarantee or accept any liability with respect to the correctness of information<br />
in this document. Copyright by Volkswagen AG.<br />
1 - Selector unit<br />
❑ Consists of selector<br />
shaft and selector shaft<br />
cover<br />
❑ Components cannot be<br />
separated from each<br />
other<br />
2 - Reversing light switch -F4-<br />
❑ Tighten to 20 Nm<br />
❑ Lightly coat lug with<br />
MoS2 grease<br />
3 - Angled rod<br />
❑ For adjusting selector<br />
mechanism<br />
❑ Removing ⇒ page 149<br />
❑ Pressing in<br />
⇒ page 149<br />
4 - Relay lever<br />
❑ Installation position<br />
⇒ page 72<br />
❑ From 05.07, plastic relay<br />
lever ⇒ page 73<br />
5 - Bearing bush<br />
❑ Not required for plastic<br />
relay lever<br />
6 - Seal<br />
❑ Lever out with a screwdriver<br />
❑ Installing ⇒ page 149<br />
7 - Hexagon nut, 23 Nm<br />
❑ Self-locking<br />
❑ Always renew<br />
8 - Gearbox selector lever<br />
❑ Install so that master spline aligns with selector shaft<br />
❑ Can be renewed with the selector mechanism installed<br />
❑ Installation position ⇒ page 72<br />
9 - Cap<br />
❑ For <strong>gearbox</strong> breather<br />
10 - Securing clip<br />
❑ Always renew<br />
❑ Not required for plastic relay lever<br />
11 - Cover plate<br />
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤<br />
5-<strong>speed</strong> <strong>manual</strong> <strong>gearbox</strong> 0A4 - Edition 04.2010<br />
12 - Spring<br />
❑ Not installed in all <strong>gearbox</strong>es.<br />
❑ Reinstall if part of original equipment.<br />
148 Rep. Gr.34 - Controls, housing
Change language