5-speed manual gearbox 0A4.pdf
5-speed manual gearbox 0A4.pdf
5-speed manual gearbox 0A4.pdf
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
❑ Do not wash out bearing; wipe only<br />
❑ Renew noisy bearings<br />
❑ Removing from and inserting in clutch release lever ⇒ page 45<br />
❑ Lubricate contact surfaces of release lever with MoS2 grease.<br />
9 - Flange bolt, 20 Nm<br />
10 - Slave cylinder<br />
❑ Removing and installing ⇒ page 40<br />
11 - Plunger<br />
12 - Assembly bolt<br />
❑ Secures clutch release lever when <strong>gearbox</strong> is installed.<br />
❑ Remove after <strong>gearbox</strong> has been installed.<br />
Note<br />
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤<br />
5-<strong>speed</strong> <strong>manual</strong> <strong>gearbox</strong> 0A4 - Edition 04.2010<br />
Removing and installing release lever together with release bearing<br />
– Unhook spring -arrow 1-.<br />
– Pull off release lever -arrow 2- and release bearing.<br />
– Install in reverse order of removal.<br />
Removing and installing release bearing<br />
– Press together locking lugs -arrows- on back of clutch release<br />
lever and remove release bearing -A- from clutch release lever.<br />
– To install, press release bearing -A- into clutch release lever<br />
until locking lugs -arrows- engage.<br />
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted unless authorised by Volkswagen AG. Volkswagen AG does not guarantee or accept any liability with respect to the correctness of information<br />
in this document. Copyright by Volkswagen AG.<br />
3. Repairing clutch release mechanism 45
Change language