5-speed manual gearbox 0A4.pdf

Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
5-speed manual gearbox 0A4 - Edition 04.2010
• Gate and selector cables -B- must be inserted, free of tension,
into locking devices -A-.
– Now turn locking mechanisms on gear selector cable and gate
selector cable end pieces clockwise to stop
-direction of arrow 1-.
The spring presses the locking mechanism into original position
-direction of arrow 2-.
– Then turn angled rod -A- back to original position in
-direction of arrow-.
Note
The angled rod -A- must be pressed out of selector housing to
stop and point to rear.
– Pull locking pin out of holes -A- and -B-.
– If noise insulation was present, install it.
– Install gaiter with selector knob and cover ⇒ page 61 .
– Check selector shaft can move freely.
– If removed, install complete air filter housing ⇒ Rep. Gr. 23 ;
Repairing diesel direct injection system or ⇒ Rep. Gr. 24 ;
Repairing injection system .
2.11.1 Functional check
• With gearbox in neutral, selector lever must rest in selector
lever gate for 3rd and 4th gear.
– Operate clutch.
– Select all gears several times. Pay particular attention to operation
of reverse gear lock.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted unless authorised by Volkswagen AG. Volkswagen AG does not guarantee or accept any liability with respect to the correctness of information
in this document. Copyright by Volkswagen AG.
82 Rep. Gr.34 - Controls, housing