5-speed manual gearbox 0A4.pdf

Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
5-speed manual gearbox 0A4 - Edition 04.2010
♦ Torque wrench -V.A.G 1331-
1.3.1 Removing
Carry out procedure as follows:
– Remove noise insulation ⇒ General body repairs, exterior;
Rep. Gr. 50 ; Noise insulation .
– Turn steering to right to full lock.
– Remove drive shaft heat shield, if present -arrows- ⇒ Running
gear, axles, steering; Rep. Gr. 40 ; Repairing drive shafts;
Removing and installing drive shafts .
– Disconnect drive shaft -1- from flange shaft.
– Tie up drive shaft as high as is possible. Take care not to
damage paint on drive shaft in the process.
– Place drip tray under gearbox and engine.
– If present, unbolt turbocharger oil return line from engine
-arrow- ⇒ Rep. Gr. 21 ; Charge air system for turbocharger,
Removing and installing turbocharger with add-ons .
– Remove flange shaft securing bolt by screwing 2 bolts into
flange and counterholding flange shaft with a lever.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted unless authorised by Volkswagen AG. Volkswagen AG does not guarantee or accept any liability with respect to the correctness of information
in this document. Copyright by Volkswagen AG.
– Pull out flange shaft with compression spring.
190 Rep. Gr.39 - Final drive - differential