5-speed manual gearbox 0A4.pdf

– Move gate selector lever back to stop, opposite from mounting
holes for gear and gate selector cable, -arrow 1-.
– Grease ball-head pin.
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
5-speed manual gearbox 0A4 - Edition 04.2010
– Press ball-head pin into gate selector lever -arrow 2-.
• Guides -A- and tabs -B- are not allowed to be damaged.
– Place selector housing with gear lever guide into larger recess
-arrow- in thrust piece -T10083- .
• The gear lever guide must project from the selector housing
up to the stop.
– Lever upper end -A- of compression spring over pin of gate
selector lever.
• Use a new ball socket -B-.
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted unless authorised by Volkswagen AG. Volkswagen AG does not guarantee or accept any liability with respect to the correctness of information
in this document. Copyright by Volkswagen AG.
– Grease ball socket and bearing ball of selector lever guide.
– Push ball socket onto bearing ball of selector lever guide to
stop.
– Remove selector housing from thrust block -T10083- .
– Insert lower end -C- of compression spring into guide.
– Lever upper end -A- of compression spring over pin of gate
selector lever into guide.
– Push ball socket into selector housing -arrows-.
• All locking lugs must clip in.
– Mount selector lever, gear selector cable, gate selector cable
and base plate ⇒ page 65 .
– Install selector mechanism ⇒ page 75 .
2. Repairing selector mechanism 69