5-speed manual gearbox 0A4.pdf
5-speed manual gearbox 0A4.pdf
5-speed manual gearbox 0A4.pdf
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Fitting position of cable tie for cables<br />
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤<br />
5-<strong>speed</strong> <strong>manual</strong> <strong>gearbox</strong> 0A4 - Edition 04.2010<br />
– Wind cable tie -arrow- around the selector cables in a figure<br />
eight and secure them as shown in figure.<br />
2.8 Plastic relay lever<br />
From 05.07, relay lever is made from plastic. 2 versions may be<br />
installed.<br />
♦ Relay lever with catch<br />
♦ Relay lever with clip<br />
Comply with the following during removal and installation work:<br />
• To remove relay lever, first separate cable end-piece from<br />
gate selector cable.<br />
This will avoid damage to the gate selector cable.<br />
Carry out procedure as follows:<br />
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted unless authorised by Volkswagen AG. Volkswagen AG does not guarantee or accept any liability with respect to the correctness of information<br />
in this document. Copyright by Volkswagen AG.<br />
– Pull locking mechanism forward to stop in<br />
-direction of arrow 1- and then lock by turning to left in<br />
-direction of arrow 2-.<br />
– Then push relay lever forwards (-direction of arrow 3-).<br />
Relay lever with catch -arrow 1-<br />
– Press catch -arrow 1- down to stop and remove relay lever<br />
together with cable end-piece. Move relay lever in operating<br />
direction.<br />
2. Repairing selector mechanism 73
Change language