5-speed manual gearbox 0A4.pdf

1.4.2 Installing
– Clean seat for seal in gearbox.
– Pull in seal and sleeve together.
A - Screw spindle of assembly tool -3066- into threaded piece of
differential.
B - Nut M12
Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
5-speed manual gearbox 0A4 - Edition 04.2010
– Pull in seal with sleeve to stop using thrust piece -T10148- by
turning nut -B-.
– Half-fill space between sealing lip and dust lip with sealing
grease -G 052 128 A1- .
– Insert flange shaft.
– Secure flange shaft with countersunk bolt.
– If turbocharger oil return line was unbolted from engine, bolt it
on again now -arrow- ⇒ Rep. Gr. 21 ; Charge air system for
turbocharger; Removing and installing turbocharger with ancillaries
.
– Bolt drive shaft -1- to flange shaft ⇒ Running gear, axles,
steering; Rep. Gr. 40 ; Repairing drive shaft; Removing and
installing drive shafts .
– Install drive shaft heat shield, if present -arrows- ⇒ Running
gear, axles, steering; Rep. Gr. 40 ; Repairing drive shafts;
Removing and installing drive shafts .
– Check and top up gear oil ⇒ page 112 .
– Install noise insulation ⇒ General body repairs, exterior; Rep.
Gr. 50 ; Noise insulation .
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted unless authorised by Volkswagen AG. Volkswagen AG does not guarantee or accept any liability with respect to the correctness of information
in this document. Copyright by Volkswagen AG.
1.4.3 Torque setting
Flange shaft to gearbox (countersunk bolt)
⇒ Item 12 (page 199)
194 Rep. Gr.39 - Final drive - differential