ATTP 5-0.1 Commander and Staff Officer Guide - Army Electronic ...

Annex C
[CLASSIFICATION]
ANNEX C (OPERATIONS) TO [OPERATION PLAN/ORDER [number] [(code name)]—
[(classification of title)]
4. (U) Sustainment. Describe priorities of sustainment by unit or area. Highlight subordinate allocations of
command-regulated classes of supply that impact movement and maneuver, such as controlled supply rates.
Include instructions for deployment or redeployment. Identify priorities of sustainment for operations key
tasks and specify additional instructions as required. Refer to Annex F (Sustainment) as required.
a. (U) Logistics. Use subparagraphs to identify priorities and specific instructions for maintenance,
transportation, supply, field services, distribution, contracting, and general engineering support. Refer to
Annex F (Sustainment) and Annex P (Host-Nation Support) as required.
b. (U) Personnel. Use subparagraphs to identify priorities and specific instructions for human resources
support, financial management, legal support, and religious support. Refer to Annex F (Sustainment) as
required.
c. (U) Army Health System Support. Identify availability, priorities, and instructions for medical care.
Refer to Annex F (Sustainment) as required.
5. (U) Command and Signal. List information in this paragraph and its subparagraphs only if annex
distributed separately from base order, otherwise state “Same as base order.”
a. (U) Command.
(1) (U) Location of Commander. State the location of key leaders.
(2) (U) Succession of Command. State the succession of command if not covered in the unit’s
SOPs.
(3) (U) Liaison Requirements. State the liaison requirements not covered in the base order.
b. (U) Control.
(1) (U) Command Posts. Describe the employment of command posts (CPs), including the location
of each CP and its time of opening and closing.
(2) (U) Reports. List reports not covered in standard operating procedures (SOPs). Refer to
Annex R (Reports) as required.
c. (U) Signal. Address any communications requirements. Refer to Annex H (Signal) as required.
ACKNOWLEDGE: Include only if attachment is distributed separately from the base order.
[Commander’s last name]
[Commander’s rank]
The commander or authorized representative signs the original copy of the attachment. If the representative
signs the original, add the phrase “For the Commander.” The signed copy is the historical copy and
remains in the headquarters’ files.
OFFICIAL:
[Authenticator’s name]
[Authenticator’s position]
Use only if the commander does not sign the original attachment. If the commander signs the original, no
further authentication is required. If the commander does not sign, the signature of the preparing staff
officer requires authentication and only the last name and rank of the commander appear in the signature
block.
[page number]
[CLASSIFICATION]
C-4 ATTP 5-0.1 14 September 2011