ATTP 5-0.1 Commander and Staff Officer Guide - Army Electronic ...

Annex G
[CLASSIFICATION]
ANNEX G (ENGINEER) TO OPLAN/OPORD [number] [(code name)]—[issuing headquarters]
[(classification of title)]
a. (U) Logistics. Use subparagraphs to identify priorities and specific instruction for maintenance,
transportation, supply, field services, distribution, contracting, and general engineering support. Refer to Annex
F (Sustainment) and Annex P (Host-Nation Support) as required.
(1) (U) Command-Regulated Classes of Supply. Identify command-regulated classes of supply.
Highlight supported unit allocations that affect engineer support (such as Class IV barrier material allocated to
other efforts).
(2) (U) Supply Distribution Plan. Establish Class IV and Class V (obstacle) supply distribution plan.
State method of supply for each class and for each supported unit subordinate element. List supply linkup
points. Identify and list all allocations of Class IV and Class V by support unit element by obstacle control
measure or combination. Summarize in a matrix or table as necessary.
(3) (U) Transportation. List any transportation coordination to include supported, troop movements,
Class IV building materials, and Class V materials.
b. (U) Personnel. Use subparagraphs to identify priorities and specific instructions for human resources
support, financial management, legal support, and religious support. Refer to Annex F (Sustainment) as
required.
c. (U) Army Health System Support. Identify availability, priorities, and instructions for medical care.
Refer to Annex F (Sustainment) as required.
5. (U) Command and Signal.
a. (U) Command.
(1). (U) Location of Key Leaders. State the location of key engineer leaders. Designate the
headquarters that controls the mobility, countermobility, and survivability effort within work lines on an area
basis. Clearly identify release authority for special munitions, such as the Intelligent Munitions System
(Scorpion).
(2) (U) Succession of Command. State the succession of command or leadership if not covered in the
unit’s standard operating procedures (SOPs).
(3) (U) Liaison Requirements. State engineer liaison requirements not covered in the unit’s SOPs.
b. (U) Control.
(1) (U) Command Posts. Describe the employment of command posts (CPs), including the location of
each CP and state the primary controlling CP for specific tasks or phases of the operation.
(2) (U) Reports. Identify critical engineer reporting requirements of subordinates if not covered in
SOPs. Refer to Annex R (Reports) as required.
c. (U) Signal. Describe the concept of signal support as it pertains to engineer support operations. Refer to
Annex H (Signal) as required.
[page number]
[CLASSIFICATION]
G-4 ATTP 5-0.1 14 September 2011