ATTP 5-0.1 Commander and Staff Officer Guide - Army Electronic ...

Engineer Annex Format and Instructions
[CLASSIFICATION]
ANNEX G (ENGINEER) TO OPLAN/OPORD [number] [(code name)]—[issuing headquarters]
[(classification of title)]
ACKNOWLEDGE: Include only if attachment is distributed separately from the base order.
[Commander’s last name]
[Commander’s rank]
The commander or authorized representative signs the original copy of the attachment. If the representative
signs the original, add the phrase “For the Commander.” The signed copy is the historical copy and remains in
the headquarters’ files.
OFFICIAL:
[Authenticator’s name]
[Authenticator’s position]
Use only if the commander does not sign the original attachment. If the commander signs the original, no
further authentication is required. If the commander does not sign, the signature of the preparing staff officer
requires authentication and only the last name and rank of the commander appear in the signature block.
ATTACHMENTS: List lower-level attachment (appendixes, tabs, and exhibits). If a particular attachment is
not used, place “not used” beside the attachment number. Unit SOPs will dictate attachment development and
format. Common attachments include the following:
Appendix 1 – Mobility/Countermobility
Appendix 2 – Survivability
Appendix 3 – General Engineering
Appendix 4 – Geospatial Engineering
Appendix 5 – Engineer Task Organization and Execution Matrix
Appendix 6 – Environmental Considerations
DISTRIBUTION: Show only if distributed separately from the base order or higher-level attachments.
[page number]
[CLASSIFICATION]
14 September 2011 ATTP 5-0.1 G-5