SINUMERIK 840D/810D ShopMill

9ToolManagement 9.3 Tool management start-up in the PLC
9-124
Initial addresses of load/unload points:
Load/unload point 1: n = 4
2: n = 34
3: n = 64
4: n = 94
Example calculation of address DBW n+24 (magazine no. target)
n = (m--1) * len + 4 m = location no. of loading location/point
len = 30 (length of a load point)
m=2; len=30 n=(2--1)*30+4==>n=34
DBW (34 + 24) = DBW 58
Address for magazine no. target of 2nd load point is DBW 58.
12.01
Load point 1 is intended for loading/unloading in all spindles. This must be
taken into account in the load interface assignment (applies to PCU 20; automatically
taken into account in PCU 50). Load point 1 is also used for relocation/positioning
of tools in any location (e.g. buffer location).
E Siemens AG, 2001. All rights reserved
SINUMERIK 840D/810D Description of Functions ShopMill (FBSP) - 12.01 Edition