You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
12.01<br />
5.2 Description of <strong>ShopMill</strong> interface DB82<br />
5.2.1 Signals to <strong>ShopMill</strong> (input signals)<br />
E Siemens AG, 2001. All rights reserved<br />
<strong>SINUMERIK</strong> <strong>840D</strong>/<strong>810D</strong> Description of Functions <strong>ShopMill</strong> (FBSP) - 12.01 Edition<br />
5SignalDescription 5.2 Description of <strong>ShopMill</strong> interface DB82<br />
DB82 transfer_base_sig<br />
DBB0 Transmission mode for MCP signals<br />
Data block Signal(s) to <strong>ShopMill</strong><br />
Edge evaluation: no Signal(s) updated: cyclically Signal(s) valid as of software version:<br />
<strong>840D</strong> SW 4.3, <strong>810D</strong> SW 2.3<br />
Signal meaning This signal specifies whether the base signals with the structure “base_sig” are to be used<br />
from the I/O area of the flat, slimline operator panel (OP032S) or from the standard slimline<br />
operator panel (OP031), i.e. the <strong>ShopMill</strong> PLC automatically copies these I/O signals to<br />
DB82.<br />
Value:<br />
0 Standard assignment; connection of a narrow-profile slimline operator panel MCP<br />
(OP032S)<br />
1 Connection of an MCP of standard slimline operator panel (OP031)<br />
² 2 Base signals are not transferred; base signals must be transferred by<br />
the operator!<br />
Note see Subsection 4.4.2 “<strong>ShopMill</strong> interface DB 82”<br />
DB82 base_sig.main_mode_mill.manual<br />
DBX2.0 <strong>ShopMill</strong> Manual operating mode<br />
Data block Signal(s) to <strong>ShopMill</strong><br />
Edge evaluation: yes Signal(s) updated: cyclically Signal(s) valid as of software version:<br />
<strong>840D</strong> SW 4.3, <strong>810D</strong> SW 2.3<br />
Signal meaning Manual operating mode (Softkey “Machine manual”) is activated in <strong>ShopMill</strong> via this signal.<br />
Corresponding to... DB82.DBB0<br />
Note Effective only when DB82.DBB0=2 is set<br />
References /BAS/, <strong>ShopMill</strong> Operator’s Guide<br />
DB82 base_sig.main_mode_mill.automatic<br />
DBX2.1 <strong>ShopMill</strong> Automatic operating mode<br />
Data block Signal(s) to <strong>ShopMill</strong><br />
Edge evaluation: yes Signal(s) updated: cyclically Signal(s) valid as of software version:<br />
<strong>840D</strong> SW 4.3, <strong>810D</strong> SW 2.3<br />
Signal meaning Automatic operating mode (Softkey “Machine auto”) is activated in <strong>ShopMill</strong> via this signal.<br />
Corresponding to... DB82.DBB0<br />
Note Effective only when DB82.DBB0=2 is set<br />
References /BAS/, <strong>ShopMill</strong> Operator’s Guide<br />
5-51