SINUMERIK 840D/810D ShopMill

Machine Data
6.1 NC machine data for ShopMill
Machine data
block ShopMill
NC machine data
with exact value
assignment (G)
NC machine data
with minimum
value assignment
(M)
NC machine data
with variable value
assignment (V)
There is a machine data block cmm.8x0 for ShopMill. This set of machine data
is part of the toolbox and comprises:
NC machine data with exact value assignment
NC machine data with a minimum value assignment
NC machine data with variable value assignment
Setting data
NC machine data with exact value assignment are machine data, which must
not be modified.
NC machine data with minimum value assignment are machine data, for which
the default value can be set higher.
NC machine data with variable value assignment are machine data for which
the default value can be set to a higher or lower value.
Note
The machine data for calibrating the probe (measuring cycles) can be found
in Section 10.5 “Machine data for execution of measuring cycles”.
When you are using a SINUMERIK 840D with NCU 573.2, MD 10050
$MN_SYSCLOCK_CYCLE_TIME must be set to 0.0025.
Set the interpolation clock cycle via MD 10050 $MN_SYSCLOCK_CY-
CLE_TIME and MD 10070 $MN_IPO_SYSCLOCK_TIME_RATIO in such a
way that a workpiece can be machined and the ”Simultaneous Recording”
function is executable.
Siemens AG, 2001. All rights reserved
SINUMERIK 840D/810D Description of Functions ShopMill (FBSP) – 12.01 Edition
6
6-69