SINUMERIK 840D/810D ShopMill

12.01
2.2 Initial start-up sequence
E Siemens AG, 2001. All rights reserved
SINUMERIK 840D/810D Description of Functions ShopMill (FBSP) - 12.01 Edition
2Installation and Start-Up
2.2 Initial start-up sequence
Please proceed as follows for installing and starting up the NC:
1. PCU
2. NC
3. PLC
2.2.1 Starting up ShopMill on a PCU 20
Installation via the
PC card
Installing the system disks on PC/PG
1. Call program sys_inst from system disk 1.
2. Select option “Install System disk on hard disk”.
3. Specify the drive on which you wish to install the system disks.
4. Specify the directory in which you wish to install the system
disks. sys_inst suggests \pcu20.sys. You can change this if
necessary.
5. sys_inst may require you to insert the 2nd system disk.
6. Exit the program with .
Installing the application disks on a PC/PG
1. Call program app_inst from application disk 1.
2. Specify the drive on which you wish to install the application
disks.
3. Specify the directory in which you wish to install the application
disks. app_inst suggests \pcu20.app. You can change
this if necessary.
4. app_inst may require you to insert the 2nd application disk.
5. Exit the program with .
Fig. 2-1 Installing on a PC/PG
2-19