You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
6Machine Data<br />
6.2 Display machine data for <strong>ShopMill</strong><br />
9721 $MM_CMM_ENABLE_TRACYL<br />
MD number Enable signal for cylinder peripheral surface transformation<br />
Default setting: 0 Min. input limit: 0 Max. input limit: 1<br />
Changes valid from: IMMEDIATE Protection level: 3/4 Unit: -<br />
Data type: BYTE Valid as of software version:<br />
<strong>840D</strong> SW 4.4, <strong>810D</strong> SW 2.4 with <strong>ShopMill</strong> SW 5.1<br />
Meaning: Activate the cylinder peripheral surface transformation function via the operator interface:<br />
6-86<br />
12.01<br />
0 = The cylinder peripheral surface transformation function is not displayed on the operator<br />
interface.<br />
1 = The cylinder peripheral surface transformation function is displayed on the operator<br />
interface.<br />
The cylinder peripheral surface transformation function can be used only if it has been started<br />
up as a standard function.<br />
References: /FB2/, M1, Kinematic Transformations<br />
9723 $MM_CMM_ENABLE_SWIVELLING_HEAD<br />
MD number Enable swivelling heads<br />
Default setting: 0 Min. input limit: 0 Max. input limit: 1<br />
Changes valid from: IMMEDIATE Protection level: 3/4 Unit: -<br />
Data type: BYTE Valid as of software version:<br />
<strong>840D</strong> SW 4.4, <strong>810D</strong> SW 2.4 with <strong>ShopMill</strong> SW 5.1<br />
Meaning: This MD can be set to select whether or not swivel heads can be used on the machine.<br />
0 = No screenforms supporting swivel heads are made available.<br />
1 = Screenforms supporting swivel heads are made available.<br />
9724 $MM_CMM_CIRCLE_RAPID_FEED<br />
MD number Rapid traverse feed for positioning on circular path<br />
Default setting: 5000 Min. input limit: 0 Max. input limit: 100000<br />
Changes valid from: IMMEDIATE Protection level: 3/4 Unit: mm/min<br />
Data type: DOUBLE Valid as of software version:<br />
<strong>840D</strong> SW 6.3, <strong>810D</strong> SW 4.3 with <strong>ShopMill</strong> SW 6.2<br />
Meaning: Use this MD to set the rapid traverse feed in mm/min for positioning on a circular path.<br />
Note<br />
For a description of the display machine data for measuring cycles, please<br />
refer to Section 10.5 “Machine data for execution of measuring cycles”.<br />
E Siemens AG, 2001. All rights reserved<br />
<strong>SINUMERIK</strong> <strong>840D</strong>/<strong>810D</strong> Description of Functions <strong>ShopMill</strong> (FBSP) - 12.01 Edition<br />
J
Change language