You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
12.01<br />
E Siemens AG, 2001. All rights reserved<br />
<strong>SINUMERIK</strong> <strong>840D</strong>/<strong>810D</strong> Description of Functions <strong>ShopMill</strong> (FBSP) - 12.01 Edition<br />
6Machine Data<br />
6.2 Display machine data for <strong>ShopMill</strong><br />
9657 $MM_CMM_CYC_MIN_CONT_PO_TO_RAD<br />
MD number Indication of variation of the smallest possible cutter radius in %<br />
Default setting: 5 Min. input limit: 0 Max. input limit: 50<br />
Changes valid from: IMMEDIATE Protection level: 3/4 Unit: %<br />
Data type: WORD Valid as of software version:<br />
<strong>840D</strong> SW 4.3, <strong>810D</strong> SW 2.3<br />
Meaning: This MD is required for contour pocket milling. This parameter is for defining by which percentage<br />
the radius of a cutter used may be smaller than the one which was used for generating.<br />
9658 $MM_CMM_CYC_MAX_CONT_PO_TO_RAD<br />
MD number Indication of variation of the greatest possible cutter radius<br />
Default setting: 0.01 Min. input limit: 0.0 Max. input limit: 10.0<br />
Changes valid from: IMMEDIATE Protection level: 3/4 Unit: mm<br />
Data type: DOUBLE Valid as of software version:<br />
<strong>840D</strong> SW 4.3, <strong>810D</strong> SW 2.3<br />
Meaning: This MD is required for contour pocket milling. This parameter is for defining by which<br />
amount the radius of a cutter used may be greater than the one which was used for generating.<br />
9659 $MM_CMM_CYC_DRILL_RELEASE_ANGLE<br />
MD number Tool orientation angle on retraction<br />
Default setting: 0.0 Min. input limit: -1 Max. input limit: 360<br />
Changes valid from: IMMEDIATE Protection level: 3/4 Unit: degrees<br />
Data type: DOUBLE Valid as of software version:<br />
<strong>840D</strong> SW 4.3, <strong>810D</strong> SW 2.3<br />
Meaning: This MD defines the spindle position (0...360_) at which the tool comes to a standstill, e.g.<br />
drill toolholder in a hole.<br />
Note:<br />
-1 means that the value for the tool orientation angle can be input in the operator interface.<br />
9660 $MM_CMM_ENABLE_PLANE_CHANGE<br />
MD number Changing to machining plane (G17, G18, G19)<br />
Default setting: 1 Min. input limit: 0 Max. input limit: 1<br />
Changes valid from: IMMEDIATE Protection level: 3/4 Unit: -<br />
Data type: BYTE Valid as of software version:<br />
<strong>840D</strong> SW 4.3, <strong>810D</strong> SW 2.3<br />
Meaning: Enable change to machining plane (G17, G18, G19):<br />
0 = Change to machining plane (G17, G18, G19) not possible<br />
1 = Change to machining plane (G17, G18, G19) possible<br />
6-79
Change language