SINUMERIK 840D/810D ShopMill

2Installation and Start-Up
2.2 Initial start-up sequence
2.2.2 Starting up ShopMill on a PCU 50
Installation via the
RS-232 interface
(FAT 32)
2-22
12.01
When you install ShopMill on the PCU 50, you can choose the ShopMill variant
you wish to use, i.e. ShopMill Classic or ShopMill Open. ShopMill Classic is the
software package previously marketed under the name ShopMill. For information
about ShopMill Open, please refer to Section 13.9 “ShopMill Open”.
Note
ShopMill uses the alarm texts and PLC messages of the standard operator
interface. For detailed information, please refer to the following publications:
References: /IAC/, Installation Guide 810D
/IAD/, Installation Guide 840D.
Preconditions:
1. The interlnk.exe application must be installed on the PC/PG.
2. The following line must be present in the config.sys file of the
PC/PG:
device = [path]\interlnk.exe /auto
([path] = path of interlnk.exe file, e.g. c:\programs)
3. Connect the PCU 50 (X6) to the serial or parallel interface on
the PC/PG.
Activate the PCU 50:
4. Switch on the control and when the message ”Sinumerik”
appears as the PCU50 is booting, press the ”Cursor down” key
and then ”Enter”.
5. Select option “Start PC Link”.
6. Enter password.
7. Intersvr opens.
Fig. 2-4 Installation via the RS-232 interface (FAT 32)
1
E Siemens AG, 2001. All rights reserved
SINUMERIK 840D/810D Description of Functions ShopMill (FBSP) - 12.01 Edition