SINUMERIK 840D/810D ShopMill

2Installation and Start-Up
2.2 Initial start-up sequence
2-28
Fig. 2-12 NC start-up
NCK reset
Transfer tool management data from directory:
tools\sd\....
TM_WO_GR.8X0
(configuration without dual gripper, e.g.
for machine with disk-type magazine)
TM_W_GR.8x0
(configuration with dual gripper, e.g. for
machine with chain magazine)
1
Load ShopMill MD from directory
tools\md\CMM.8X0
Note:
This file also contains the MD for TOOL-
MAN, which may have to be adapted to
the machine.
NCK reset
Load definitions from directory:
tools\cycles\define
Activate definitions by selecting
softkey “Activate”
Load ShopMill cycles from directory:
tools\cycles
Note: After loading, the ShopMill cycles
are stored in directories Standard Cycles
and Manufacturer Cycles.
PCU 50: Load the ShopMill cycles with
”Load” softkey
Note: These data must be adapted if MD
has been modified for tool management
12.01
E Siemens AG, 2001. All rights reserved
SINUMERIK 840D/810D Description of Functions ShopMill (FBSP) - 12.01 Edition