6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>STEPP</strong>CONFIG VERSION 1.8.14<br />
PORT It is intended <strong>for</strong> changing the present status of the <strong>STEPP</strong><br />
digital outputs and its specifies the index of<br />
output ports.<br />
KEY It is intended <strong>for</strong> configuring the digital inputs of the<br />
<strong>STEPP</strong> and its specifies the index of digital<br />
inputs.<br />
IN It is intended <strong>for</strong> configuring the analogue inputs of the<br />
<strong>STEPP</strong> and its specifies the index of analoge<br />
inputs.<br />
TEL It allows you to define the phone numbers which have to<br />
be saved in the access/authorization list, and the <br />
specifies the entry index of list.<br />
VOL It allows you to adjust the loudspeaker and microphone<br />
volume levels.<br />
LOG It allows you to modify/set the parameters <strong>for</strong> the history<br />
data.<br />
ACK It allows you to activate/deactivate the confirmation of<br />
SMS sent by <strong>STEPP</strong>.<br />
GSMWRST() It allows the <strong>STEPP</strong> device to reset the GSM core in<br />
amount of time.<br />
Fehler! Verweisquelle konnte nicht gefunden werden. It allows you to<br />
determine the amount of time to wait <strong>for</strong> data<br />
transmission.<br />
MSG It allows you to configure the <strong>STEPP</strong> device <strong>for</strong><br />
periodically delivering of GPS protocols.<br />
IGN It allows you to monitor an abandoned vehicle fitted with<br />
<strong>Falcom</strong> <strong>STEPP</strong>.<br />
GEOMSG It allows you to configure the <strong>STEPP</strong> to get the geofencing<br />
messages periodically or only one-time.<br />
GEO It allows the <strong>STEPP</strong> device to determine an area<br />
(geofencing region).<br />
DEL It allows you to specifiy a delimiter in the received SMS<br />
messages.<br />
<br />
It specifies the value(s) of the entered parameter name. The value<br />
depends on the parameter name to be handled; please, refer to the chapter<br />
6.3. In that chapter you will find more details about the supported<br />
parameter.<br />
Notes<br />
• If more than one parameter has to be sent within a SMS message<br />
(command), they should be separated by colons [:]. In the table above,<br />
the type is used to initiate that type of GSM connection is SMS.<br />
The is the phone number to connect to and is the<br />
text to be sent. Keep in mind that the length of text within a SMS is<br />
limited to 160 characters.<br />
• If no authorized numbers are set, the device accepts all incoming calls<br />
and messages. To prevent the <strong>STEPP</strong> device from accepting all calls<br />
and messages, up to ten authorized numbers are available.<br />
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.<br />
Page 102