6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>STEPP</strong>CONFIG VERSION 1.8.14<br />
$GPIOP<br />
8-Bit value – Input<br />
8-Bit value – Output<br />
Value analogue input 1<br />
Value analogue input 2<br />
Value internal battery voltage<br />
GPS<br />
Status protocol<br />
I I I I I I I I - Input-Bits KEY8..KEY1<br />
OOOOOOOO - Output-Bits PORT8..PORT1<br />
adc1 – A/D – Wandler 1 – Molex Pin2<br />
adc2 – A/D – Wandler 2 – Molex Pin4<br />
Voltage of internal battery<br />
configured GPS protocol<br />
In the example the inputs / outputs marked red have<br />
been set.<br />
I I I I I I I I = Input 2 and 8 (Ignition) active<br />
OOOOOOOO = Output 1 and 3 activated<br />
$GPIOP,01000010,00000101,0.00,0.00,4.07*70<br />
The below schematic shows the structure and description (of each bit) of the<br />
$GPIOP protocol message.<br />
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.<br />
Page 114
Change language