6 Configuration commands - for Falcom STEPP

STEPPCONFIG VERSION 1.8.14
SMS
command
NMEA
message
6.3.10 LOG
How the parameter could be sent:
&CNF UNIT VOL=10,12
$PSRF108,VOL=10,12*44
Syntax LOG=,,,,,,
SMS
command
NMEA
message
Configuring triggers specifies to the STEPP device under what
circumstances a position should be logged to memory. This parameter
allows you to specify/modify the parameters of the history data. The history
logging depends on the view satellites and the minimum or maximum time,
distance and speed. If all minimum values or just one maximum value is
exceeded, then the STEPP begins storing the NMEA protocols in the
history.
Once all parameters required for the new configuration have been specified,
transfered (via SMS or locally) and accepted from the device, the STEPP
begins to implement the parameters.
New configurations take effect immediately, so they become permanently
enabled until changed.
It determines the minimum number of in view satellites able to start
the history logging.
It specifies the minimum time. The unit is second [s]
It specifies the maximum time. The unit is second [s]
It specifies the minimum distance. The unit is meter [m]
It specifies the maximum distance. The unit is meter [m]
It specifies the minimum speed. The unit is kilometer per hour [km/h]
It specifies the maximum speed. The unit is kilometer per hour [km/h]
How this command could be sent:
&CNF UNIT LOG=4,5,3600,0,0,0,0
$PSRF108,LOG=4,5,3600,0,0,0,0*7F
Notes
• To understand and to set properly the ,, and
, , and parameters, please, refer to the
chapter 5.1.2. In that chapter you will find detailed information.
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.
Page 90