6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>STEPP</strong>CONFIG VERSION 1.8.14<br />
accepting all calls and messages, at least an authorized number has to<br />
be available in the authorized list.<br />
• If a message including one of the a<strong>for</strong>ementioned parameter is sent<br />
without value then the corrent value of that parameter stored into the<br />
FLASH memory will be deleted (deactivated).<br />
• The events of $GPIOP protocol can also be stored in the history data.<br />
6.5.2 $PSRF103,[msg],00,[rate],01[*CkSum] Select protocols to<br />
be sent to<br />
Command $PSRF103,,00,,01<br />
Examples $PSRF103,00,00,00,01*24<br />
$PSRF103,00,00,01,01*25<br />
$PSRF103,01,00,00,01*25<br />
$PSRF103,01,00,01,01*24<br />
$PSRF103,02,00,00,01*26<br />
$PSRF103,02,00,01,01*27<br />
$PSRF103,03,00,00,01*27<br />
$PSRF103,03,00,01,01*26<br />
$PSRF103,04,00,00,01*20<br />
$PSRF103,04,00,01,01*21<br />
Command Description<br />
This command is used to control the output of supported NMEA<br />
messages GGA, GLL, GSA, GSV, RMC, GPIOP and GPGSM. Using<br />
this command message, NMEA messages may be polled once, or setup<br />
<strong>for</strong> periodic output.<br />
Parameter Description<br />
<br />
It specifies the NMEA message which will be configured. Following<br />
values are available:<br />
00 corresponds to the GPGGA message<br />
01 corresponds to the GPGLL message<br />
02 corresponds to the GPGSA message<br />
03 corresponds to the GPGSV message<br />
04 corresponds to the GPRMC message<br />
07 corresponds to the GPIOP message<br />
08 corresponds to the GPGSM message<br />
00<br />
predefined value<br />
<br />
specifies the message period in seconds. Following values can be set:<br />
00 disables the message specified in the field<br />
01 enables the message specified in the field<br />
01<br />
predefined value.<br />
<br />
CheckSum has to be calculated.<br />
Notes<br />
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.<br />
Page 112