6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>STEPP</strong>CONFIG VERSION 1.8.14<br />
GEOMSG parameter and then initialize the Master region via &CNF<br />
WATCH (feature of the firmware 1.6.2 and earlier versions) by using two<br />
separated SMS.<br />
Parameter Description<br />
Optional positive number, unit is meter. Place the vehicle into a<br />
restricted circle zone, whereby the current position (including<br />
Latitude and Longitude) of the <strong>STEPP</strong> is the center of circle and<br />
is the radius of circle.<br />
String, the SMS message which will be delivered from the <strong>STEPP</strong><br />
device to the target phone number specified by the<br />
GEOMSG parameter. This parameter is optional, up to 20<br />
character can be set.<br />
<br />
It specifies the type of alarm. It can be set to S, D, V or A corresponding<br />
to a SMS alarm, Data call, Voice call or Alarm (listen-in mode) call<br />
respectively, see also section 4.3.1.2.1 and 4.3.1.2.2.<br />
<br />
It specifies the phone number where the alarm has to be sent.<br />
<br />
It specifies the minimum number of satellites in view (recommended > 3)<br />
<br />
It specifies the minimum time. The unit is second [s]<br />
<br />
It specifies the maximum time. The unit is second [s]<br />
<br />
It specifies the minimum distance. The unit is meter [m]<br />
<br />
It specifies the maximum distance. The unit is meter [m]<br />
<br />
It specifies the minimum speed. The unit is kilometers per hour [km/h]<br />
<br />
It specifies the maximum speed. The unit is kilometers per hour [km/h]<br />
<br />
It defines the input NMEA messages (see chapter 6.2) that will be sent to<br />
the message recipient, only if the alarm type is set to S (<strong>for</strong><br />
SMS).<br />
Notes<br />
• A SMS alarm message is issued, if the vehicle fitted with <strong>STEPP</strong><br />
moves beyond the user-defined master region. Please, note that, if<br />
master region is activated, other set Geo-fencing areas are deactivated.<br />
• If the value is set to 0, then the device deactivates the master<br />
region and automatically activates the other set Geo-fencing areas (if<br />
defined).<br />
• !!!! Please note that, operating with firmware 1.6.2 and earlier versions,<br />
you have to configure first the destination number where the SMS<br />
alarm should be sent to. This could be done by using the command:<br />
&CNF UNIT GEOMSG=S012345678,3,60,0,0,0,0,0,IOPRMC<br />
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.<br />
Page 108