6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>STEPP</strong>CONFIG VERSION 1.8.14<br />
• If the type (if the entered parameter supports it) of GSM<br />
connection is set to D, V or A corresponding to a Data call, Voice call<br />
or Alarm (listen-in mode) call respectively, no text and protocol<br />
are required.<br />
• The values of the loudspeaker and microphone volumes recommanded<br />
to be specified at 6.<br />
• If a message including one of the a<strong>for</strong>ementioned parameter is sent<br />
without value then the current status (value) of that parameter stored<br />
into the FLASH memory will be deleted (deactivated).<br />
• In the history of <strong>STEPP</strong> the events of $GPIOP protocol can also be<br />
saved.<br />
6.4.2 &CNF [PWD] PASS Define a password <strong>for</strong> SMS configuration<br />
Command &CNF [PWD] PASS <br />
Examples &CNF abd123 PASS gbdr1212<br />
&CNF PASS gbdr1212<br />
&CNF gbdr1212 PASS<br />
Command Description Define a password <strong>for</strong> the target device<br />
Use this command when you want individually to define or to change a<br />
password specified <strong>for</strong> the lock of unidentified accesses. A password<br />
consists of a string of numeric digits with a length in the range of upto 40<br />
characters. Additionaly, the password may also be configured using the<br />
PWD parameter name. Accordingly, the password may be called "device<br />
password". The password is not associated with the PIN of the SIM card.<br />
Parameter Description<br />
<br />
It specifies the password <strong>for</strong> the configuration by SMS. Password<br />
consists of a string with a length upto 40 characters.<br />
Notes<br />
• The unblocking procedure is per<strong>for</strong>med, if no password value<br />
is allocated, whereby the old password [PWD] has to be<br />
included. If you have <strong>for</strong>gotten the parameter [PWD], the unblocking<br />
procedure is described in chapter 8.1.1.<br />
6.4.3 &REQ [PWD] POS [n] Request vehicle position with defined period<br />
Command &REQ [PWD] POS <br />
Examples &REQ PWD POS 0<br />
&REQ PWD POS 5<br />
&REQ POS 10<br />
Command Description<br />
Using this command the <strong>STEPP</strong> device position can be requested, either <strong>for</strong><br />
just one time or periodically. The position (a SMS message containing the<br />
$GPGGA and $GPRMC NMEA sentences) is returned to the message<br />
sender.<br />
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.<br />
Page 103
Change language