6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>STEPP</strong>CONFIG VERSION 1.8.14<br />
reset, but it happens only if no data can be received from <strong>STEPP</strong><br />
device via data connection. The countdown starts after receiving<br />
“Connect 9600 ...” and no data can be transmitted.<br />
- The entry in field (21) will be the operation’s time of GSM core. If<br />
the entered time in minutes runs out the GPS core per<strong>for</strong>ms a reset,<br />
but it only happens if no satellites are in view. This procedure<br />
repeats itself until the acquisition of satellites <strong>for</strong> a GPS fix is<br />
successful.<br />
4.2.3.1.2 Alarm key configuration<br />
Image 10: <strong>Configuration</strong> of alarm keys<br />
Entry Description<br />
Key1 (1) Alarm input 1<br />
Key2 (1) Alarm input 2<br />
Key3 (1) Alarm input 3<br />
Key4 (1) Alarm input 4<br />
IGN (1) Alarm input IGNITION<br />
BAT (1) Alarm input BATTERY<br />
Phone number (2)<br />
Entry of target telephone number <strong>for</strong> the respective<br />
alarm message.<br />
Alarm text (3) Entry of alarm text <strong>for</strong> the respective alarm message.<br />
Protocol/type (4)<br />
Send (5)<br />
Entry of the alarm type <strong>for</strong> the respective alarm<br />
message. Please read the chapter <strong>Configuration</strong> of<br />
alarm inputs.<br />
Saves the configuration of the respective alarm<br />
entries in <strong>Falcom</strong> <strong>STEPP</strong><br />
Table 7: <strong>Configuration</strong> of alarm inputs<br />
This chapter explains the configuration of one of the most important functions<br />
of the <strong>Falcom</strong> <strong>STEPP</strong>: the alarm input configuration.<br />
The required command (<strong>for</strong> a directly connected <strong>Falcom</strong> <strong>STEPP</strong>) is:<br />
$PSRF108,KEY[1..8]=target telephone number,alarm text,Flag*15<br />
The parameters have the following meaning:<br />
• KEY[1..8] denotes the respective alarm input<br />
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.<br />
Page 36