6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>STEPP</strong>CONFIG VERSION 1.8.14<br />
6.8 Vehicle Location<br />
Transferring the GPS protocols of a <strong>Falcom</strong> <strong>STEPP</strong> to an alarm centre, which<br />
should be equipped with a <strong>Falcom</strong> SWING, TANGO or an A2D-1 as a GSM<br />
modem, can be done in the following ways:<br />
• Via a data line which has been initiated in the <strong>STEPP</strong>config.<br />
• Via recurring SMS transmission, which was initiated after a SMS &REQ<br />
POS was sent to the <strong>Falcom</strong> <strong>STEPP</strong>.<br />
• Via a data line, which was initiated by <strong>STEPP</strong>config after a SMS<br />
&REQ [Password] CONNECT <br />
was sent to the <strong>Falcom</strong> <strong>STEPP</strong>. After receiving the SMS, <strong>Falcom</strong> <strong>STEPP</strong><br />
will automatically establish a data line to the number entered under , and transfer the NMEA protocols.<br />
• Via a data line which was triggered by <strong>Falcom</strong> <strong>STEPP</strong> due to an alarm.<br />
The configuration in <strong>Falcom</strong> <strong>STEPP</strong> could be:<br />
$PSRF108,KEY1=D01234567,Alarm 1*73<br />
In case of an alarm, this would establish a data line by activating alarm<br />
input 1 to the telephone number 01234567.<br />
Via a data line from any GSM modem, provided no entries have been made to<br />
the list “authorized phone numbers”<br />
From a GSM modem whose number has been entered into the list of<br />
“authorised phone numbers”, and if that number has been flagged with a <br />
<strong>for</strong> data, or if no flag has been set <strong>for</strong> the type of call.<br />
In the latter case, a data line will always be established.<br />
Important in<strong>for</strong>mation:<br />
1. The number contained in the list of “authorized phone numbers” must<br />
match exactly with the number transmitted via the GSM network.<br />
2. The transmission of one’s own number via the GSM network must not be<br />
deactivated (AT+CLIR=0 or 2).<br />
3. Each telephone number may only appear once into the list of “authorized<br />
phone numbers”.<br />
A duplicated entry with different call type flags is not allowed.<br />
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.<br />
Page 117