6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>STEPP</strong>CONFIG VERSION 1.8.14<br />
It specifies the target phone number where the GSM call connection has to<br />
be established. The specified call number should to be <strong>for</strong> voice call.<br />
Notes<br />
• If no number is given, the device will start a voice or alarm call to the<br />
message sender.<br />
6.4.8 &REQ [PWD] START [latitiude],[longitude] Request vehicle position<br />
every defined period (d)<br />
Command &REQ [PWD] START ,<br />
Examples &REQ PWD START<br />
&REQ PWD START 50.70 10.98<br />
Command Description<br />
The GPS system can be reset to a particular latitude and longitude using<br />
this SMS message. This command resets the GPS receiver and GSM<br />
engine of the <strong>STEPP</strong> as well.<br />
Parameter Description<br />
<br />
It specifies the Latitude of the device. Its unit is degree.<br />
<br />
It specifies the Longitude of the device. Its unit is degree.<br />
Notes<br />
• If the message sender knows the coordinates of the <strong>STEPP</strong> device, the<br />
latitude and longitude can be specified <strong>for</strong> a quick position fix.<br />
6.4.9 &CNF [PWD] WATCH [radious],[text] (f) Set a master region<br />
Command &CNF [PWD] WATCH ,<br />
&CNF [PWD] WATCH ,,,,<br />
,,,, ,, (g)<br />
Examples &CNF PWD WATCH 200,enters the zone<br />
&CNF PWD WATCH 200,enters the zone,S0125156105,4,0,0,0,0,<br />
0,0,RMC<br />
&CNF PWD WATCH 0<br />
Command Description<br />
This SMS command can be per<strong>for</strong>med by monitoring an abandoned vehicle<br />
fitted with <strong>STEPP</strong> device. Sending this command, the <strong>STEPP</strong> device<br />
generates automatically a Master region (GEO00) with a given <br />
value. The center of generated circle region is the current <strong>STEPP</strong> position. If<br />
the wehicle goes out of this Master region, an alarm will be sent to the predefined<br />
phone number from the GEOMSG parameter.<br />
The firmware 1.6.5 and greater versions support the GEOMSG settings to<br />
be included into the &CNF WATCH as one line (command). So a Master<br />
region can be configured at once, instead of sending at first the command<br />
d<br />
The Firmware 1.05 and greater versions support this SMS command.<br />
f<br />
The Firmware 1.6 and greater versions support this parameter.<br />
g<br />
The Firmware 1.6.5 and greater versions support this parameter settings<br />
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.<br />
Page 107