6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
6 Configuration commands - for Falcom STEPP
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>STEPP</strong>CONFIG VERSION 1.8.14<br />
6.3.11 ACK (c)<br />
• If all , and limits are exceeded, a history record<br />
will be stored. Any null value is ignored.<br />
• If any of ,, limits is exceeded, a history record<br />
will be stored. Any null value is ignored.<br />
Syntax ACK=<br />
This parameter enables you to activate/deactivate the confirmation of SMS<br />
sent by <strong>STEPP</strong>. If active it confirms successful receipt of a new message<br />
(SMS delivering or SMS status report) routed directly to the message<br />
sender. Device shall manually disable routing to the message sender by<br />
setting the value to zero. Default setting is 1.<br />
<br />
Indicates that new SMS status report whether or not has to be<br />
received. Following values are available <strong>for</strong> use:<br />
0 no indications (confirmations) are routed to the message<br />
sender.<br />
1 indications (confirmations) are routed to the message sender.<br />
How the parameter could be sent:<br />
SMS &CNF PWD UNIT ACK=0<br />
command &CNF PWD UNIT ACK=1<br />
NMEA $PSRF108,ACK=0*46<br />
message $PSRF108,ACK=1*47<br />
Notes<br />
• If value is set to 1, the <strong>STEPP</strong> device will send back a response<br />
to indicate the new configuration has correctly been received and upon<br />
success the result code representation “ OK” will be displayed<br />
to the message sender. If the sent command was a bad command or has<br />
a bad parameter the result code representation “ bad command”<br />
or “ bad parameter” will be displayed to the message sender<br />
respectively. The response message representation always corresponds<br />
to the sent command.<br />
• The device shall not send another result code to message sender until<br />
previous one is acknowledged (assumed the value has been set<br />
to 1).<br />
6.3.12 GPSRESET (c)<br />
Syntax GPSRESET=<br />
GPSRESET=,<br />
This parameter allows the <strong>STEPP</strong> device to reset the GPS core (in user<br />
defined interval of time). It will occur only if the <strong>STEPP</strong> is unable to<br />
c<br />
The Firmware 1.4 and greater versions support this parameter<br />
c<br />
The Firmware 1.4 and greater versions support this parameter.<br />
g<br />
The Firmware 1.6.5 and greater versions support this parameter setting<br />
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.<br />
Page 91
Change language